Aug 12, 2021 · :titanium heat exchanger
The heat transfer area of a gasketed plate heat exchanger consists of a series of corrugated plates, assembled between a frame and pressure plates to retain pressure. Gaskets act as seals between the plates. Fluids normally run counter-currently through the heat exchanger. Alfa Laval - ProductsGasketed plate heat exchanger double wall. Alfa Laval double-wall plate heat exchangers are ideal for use with fluids that must not mix because of environmental effects, deterioration of process fluids or because it would be hazardous. In case of a leak, the fluid will flow out of the heat exchanger instead of being mixed with the second stream, making detection of leakages fast and easy.
Product Range. Our plate heat exchangers have a wide range from 0.23 ft to 19.81 ft per plate with nozzle sizes from 34 to 12/14 . Our plate packs have varied chevron angles to allow the maximum turbulence and velocity for a given pressure drop. Our range of sizes and plate patterns permit the precise optimization of the heat exchanger Gasketed Plate Heat Exchangers HRS Heat ExchangersHRS Gasketed Plate Heat Exchangers are manufactured as standard from either AISI 304/316 stainless steel or titanium to a thickness of 0.6mm, although plate thickness options of 0.8mm or 1.0mm are also available if required. The exchangers are fitted with EPDM or NBR gaskets with the frames constructed from painted carbon steel.
Gasketed plate heat exchangers. Alfa Laval gasketed plate heat exchangers are the most cost-effective solution . available for HVAC heating and cooling applications. Our gasketed plate heat exchanger range is the result of decades of experience, research and development in heat transfer technology. By combining innovative design Plate & Frame Heat ExchangersMuellers double-wall Accu-Therm plate heat exchanger is constructed with two identical plates nested together. Each of the double-wall pairs are fully welded or uniquely gasketed at the port locations, creating a two-layer heat transfer wall.
Double-wall units prevent intermixing of fluids due to a plate failure. Two plates are pressed together to ensure a tight fit to minimize heat transfer losses while maintaining a leak path in case of plate failure. Double Wall Plate Heat Exchanger Valutech Inc.Double Wall Plate Heat Exchanger Design and construction The Double-Wall Plate Heat Exchanger works on the same principle as a conventional plate heat exchanger but differs in that the single plates between the two media are replaced by plate pairs
Your email address will not be published.*